Check the power supply and air source of the mask machine

Fifty percent of the reasons for the failure of the ultrasonic mask machine equipment are due to power supply and gas source problems. For example, due to power supply problems, problems such as insurance burning, poor plug contact and low power supply will be caused; due to the abnormal opening of the air pump, there will be phenomena such as the inability of the pneumatic parts to be turned on normally. Therefore, it is recommended that when the ultrasonic mask machine fails, you should give priority to checking these conditions to see if the position of the sensor is offset.

Many failures of the ultrasonic mask machine are often related to the position of the sensor. The equipment will inevitably produce vibration during use. With the increase of the number of vibrations, the sensor may be displaced due to loosening. When the position of the sensor appears When it is offset, it will affect its sensitivity and sensitivity, and there will also be warning signals, reminding everyone to regularly check and correct the position of the sensor, so as not to affect the normal use of the equipment;

Regular inspection of relays and other components.

The ultrasonic port placement relay is actually the same as the sensor during use. If it is used for a long time without paying attention to maintenance and maintenance, there will be adhesion, which will lead to abnormal electrical circuits. At the same time, the pressure adjustment spring of the throttle valve will also be due to The vibration of the equipment slips and loosens, which will lead to abnormal work of the mask equipment, so we should carry out regular maintenance of the relay, pressure valve, etc.